Used Gloucester Process Equipment
Stock No.:
10755143Used Gloucester 2522 R2 2.5" Extruder – 60 HP, 32:1 L/D, Reconditioned
Used-Gloucester Model 2522 R2 2.5" 32:1 L/D Extruder with an electrically heated, water cooled (closed loop) vented and plugged barrel at approximately a 72" centerline height. Gearbox has a reduction ratio of 10.73:1 and is direct driven by a 60 HP D/C motor with Saftronics SCR control. Manual screen changer mounted on the extruder discharge. Includes panel with controls. Reported to be reconditioned.
MFR: Gloucester
Stock No.:
10755144Used Gloucester 2.5" Single Screw Extruder – 32:1 L/D, Air-Cooled & Vented
Used- Gloucester 2.5" Extruder 32:1 L/D five (5) zone air cooled and vented barrel at a 45" centerline height. Top center feed throat. Driven by a 50 HP A/C 1750/2100 RPM motor, includes 6 zone temperature control panel and 5-hole strand die
MFR: Gloucester
Stock No.:
10755152Used Gloucester 25225R2 Single Screw Extruder – 2.5" Dia., 32:1 L/D, 60 HP Motor
Used- Gloucester Single Screw Extruder, Model 25225R2. 2.5' Diameter Screw, 32:1 L/D. Has an electrically heated, air cooled, and non-vented barrel at approximately a 65? center line height. Barrel is set up for Contra-Cool but does not include blower. Gearbox has a reduction ratio 13.75:1 and is direct driven in a wraparound manner by a 60 HP Baldor D/C motor with Saftronics SCR control. One (1) HP pump with heat exchanger on the gearbox. Originally manufactured in 1995 and completely reconditioned in 2011 and never put back into service. All wiring on the extruder is run to a terminal strip. New control panel has fourteen (14) zones of temperature controls. Drive control is supplied loose. Includes two (2) new / rebuilt screws. 460/3/60. Serial# 36736/25.
MFR: Gloucester
Stock No.:
10755151Gloucester Model 35250R2 3.5" Diameter Single Screw Extruder – Industrial Used
Used- Gloucester Model 35250R2 3.5" Diameter Single Screw Extruder. 3.5" diameter screw, 32:1 L/D. Has an electrically heated, air cooled, vented, and plugged barrel at approximately a 65? center line height. Barrel is set up for Contra-Cool but does not include blower. Gearbox has a reduction ratio of 18.17:1 and is direct driven in a wraparound manner by a 100 HP Baldor D/C motor with Saftronics SCR control. One (1) HP pump with heat exchanger on the gearbox. Originally manufactured in 1995 and completely reconditioned in 2011 and never put back into service. All wiring on the extruder is run to a terminal strip. New control panel has fourteen (14) zones of temperature controls. Drive control is loose. Includes three (3) new / rebuilt screws. 460/3/60. Serial# 36736/12.
MFR: Gloucester