Used Winding & Unwinding Equipment
Below is Aaron's inventory of unused and used winding and unwinding equipment. If you are looking to sell your used winding and unwinding equipment submit a request online or contact Erik Eichert at 630-238-7480.
Stock No.:
1015103772" Dusenberry Model 815 Duplex Score Cut Slitter-Rewinder
Used- 72" Dusenberry Model 815 Duplex Score Cut Slitter-Rewinder. Having a 25 hp DC and 15 hp DC dual drive system with score slitting assembly duplex differential center wind. Presently set up for one zone control per winding shaft for maximum 28" diameter rolls on 3" cores. Separate Dusenbery Model 863 AK single station unwind for 40" diameter mill rolls on 3" cores with fife guide edge system..
MFR: Dusenberry Engr
Stock No.:
76515Used - GEC Dual Turret Winder, Model 123-12638-2, 80” Wide
Used GEC Dual Turret Winder, Model 123-12638-2. Handles rolls approximately 80" wide and up to 18" in diameter, ideal for blown or cast film lines, paper/board lines, and flexible packaging operations requiring continuous wide-web winding. The dual-turret design enables non-stop production by pre-loading new cores while finished rolls discharge, significantly reducing changeover downtime and labor versus single-station winders. Mechanical and structural condition reported as good, subject to buyer inspection; photos and inspection available. A high-value production asset priced well below comparable used high-end winders and a fraction of new equipment at this capability.
MFR: GEC