Used Sheet Dies

Stock# 43309005

Used- PTI Circular Foam Sheet Die. Includes a cooling mandrel, and a DT Industires/Sencorp foam distribution system, model DSM 564, serial# 12159615069, 115 volt, 6 amps. Last used with a 4-1/2" PTI extruder, 48 to 1 L/D ratio.

Stock# 43446026

Used- Extruder 6" Die Clamp On Stand.

Stock# 45856037

Used- Ribbon Slot Die 10". Fed from 1.5" heated feed throat, 8.5" diameter feed side.

Stock# 50518069

Used- EDI Extrusion Dies 20” Wide Ultraflex Flex Lip Sheet Die, Model H-75. Approximate 1" back center feed. Serial# 88-11727.

Stock# 88457

Used- Cloeren 22" Wide Manual 3 Layer Flex Lip Extrusion Die With Co-Ex Block. Built 2002.

Stock# 50518068

Used- Allied Die 24" Wide Flex Lip Sheet Die, Model AD. Approximate 1" back center feed. 1/460 Volt.

Stock# 46471011

Used- Flex Lip Sheet Die, 29" wide, back center feed, dual R bars, removable lower lip, with manual decklling, serial# 89263/700/L5-CR.

Stock# 50518173

Used- EDI Extrusion Dies Fully Refurbished 41" Wide Ultraflex Flex Lip Sheet Die, Model R-75. Slotted back center feed. Serial# 76-2385-2, refurbished 1-22-2019.

Stock# 50518074

Used - EDI Die Lips, 41" die, qty (7)

Stock# 40094003

Used- 42" Cloeren Model Epoch V Sheet Die. .001"-.030" lip opening range, .03 neutral opening, 36-39-RC tool steel, hard chrome plated .002-.0025, five heat zones, 240 volt, 2002 vintage.

Stock# 43752013

Used- EDI 44" Flex Lip Sheet Die. Back center feed, no chocker bar, fixed bottom lip.

Stock# 43554004

Unused- 52" EDI Dual Entry Sheet Die, Model 52U/F R75. With restrictor bar and fast gap control, serial # 08-27852, built 2008.

Stock# 40094001

Used- 55" Cloeren, Model Epoch V, Sheet Die. Equipped with AutoGauge 5 Push/Pull adjustable lip, 0-.04" gap range, tool steel, .001 Electroless nickel plating, 5 zones, 240 volt, 1992 vintage, die.

Stock# 40094002

Used: 55" Cloeren Model Epoch V Sheet Die. Equipped with Auto Gauge 2 Push/Pull adjustable lip, 0-.04" gap range, 28-32RC high alloy tool steel, .0015 Electroless nickel plating, 5 zones, 240 volt, 1992 vintage.

Stock# 40617015

Used- EDI 55" Wide Ultraflex Film/Laminating Die, model H40. End feed design. Last used for polystyrene film onto polystyrene foam sheet.

Stock# 50518164

Used- EDI Extrusion Dies 60” Wide Sheet Die. Back center feed with adapter. Serial#12-31509-1.

Stock# 40453018

Used- EDI 3-manifold sheet die having a 78" slot opening with an upper adjustable lip, fixed removable lower lip and (2) restrictor bars. Presently installed is lower lip for gap range from .394 to 492.

Stock# 44774005

Used- EDI 94" Autoflex AFII H40C Sheet Die. Approximately 2" diameter back center feed. Lip opening .001 to .030. Serial # 86-10722-1