Used Blow Molding Equipment

Stock# 50301001

Used- Amsler Two Cavity Reheat Stretch Blow Molding Machine, Model L22. Currently Set up to produce 200 ml to 2 liter bottles in neck finishes from 23 - 43 mm at rates up to 2400 bottles per hour. Touch screen programming. Includes chiller, air compressor and descrambler. Mfg. 1977.

Stock# 50357001

Used- Krones Contiform S-10 Blow Molding Machine. Maximum Output 16,000 Fl./h - bph. (10) Blowing Stations. Maximum Fill Volume 2.25 liters, Minimum Fill Volume 0.25 Liters. Maximum Bottle Height 350 mm, Minimum Bottle Height 120 mm. Maximum Bottle Diameter 120 mm, Maximum Length 200 mm, Minimum Length 60 mm. Support Ring Diameter 30-48.3 mm. Inner body diameter 10-39 mm. Height of neck finish 11-35 mm. Maximum diameter of thread groove 24.9-42 mm; Mfg. 2003.

Stock# 50737001

Used Sacmi IPS 220 48 Head Injection PET System. M7CA14029/23050 Controls, Pumps,48 Cavity Mould, 16G Cycle Time 7 Seconds, 36G Cycle time 13 Seconds. Last used on PET Plastic Water Bottles.

Stock# 50737002

Used- Sacmi SBF408 Blow Mould Machine. 21,600 Bottles/Hour, 500ml Bottles. Includes Control Panel, Vacuum System and Transformer.

Stock# 50730001

Used- Continuous Extrusion Blow Molding Line. Consisting of: Tonva Blow Molder, Model TVHS-5L-IV, with Moog Parison Controller and servo control, Mixer, Auto Loaders, 10 hp Water Chiller, Single Head Leak Tester, Horizontal Scrap Conveyor Belt, 10 hp Compressor with Receiver and Dryer, Neck Trimmer. Molds (128 oz, 64 oz, 32 oz, 16 oz, 8 oz, 3.4 oz) with Mandrels, Die Pins and Blowpins. Additional Neck Inserts for Induction Heat Seal Neck Finish, Tamper Evident Ratchet Neck Finish, Tamper Evident Snap Band Neck Finish. Recycle Logo Insert for "HDPE" (2) or "Other" (7) Logo. Spare Parts: 15 kw Drive, 2.2 kw Drive, Electrical Sensors, Heater Bands, and Spare Blow Pins.