Waste Water Equipment

Used Trailerized Multiquip Model DCA-70SSIU2fDiesel Generator

Used- Multiquip Trailerized Diesel Generator, Model DCA-70SSIU2. Rated 56 kW; 3/60/240/480V; 85 HP, 1800 RPM Isuzu 4JJ1x engine; 1774 hours.

MFR: Multiquip

Alloy Fabricators Inc. approximately 5600 gallon mix tank

Used Alloy Fabricators Inc. approximately 5600 gallon 304 stainless steel vertical mix tank. 90" diameter X 17' high straight side. Internal rated ATMOS @ 200 F. Dished heads. Top fittings: 21" manway, (2) 1.5", (4) 2", (1) 3", and (1) 4". 3" center bottom drain. Has (4) internal baffles. Equipped with dual flight 4-blade agitator driven by Philadelphia model PTERVS-08 S/N 307572, Ratio 38.9-1. Rated 1750 RPM input, 45 RPM output. Powered by 5 HP 3/60/460 volt motor. Lug mounted. Built 1979 OAH 27'

MFR: Alloy Fab

Used Mueller 5,700 Gallon Jacketed Pressure Tank | 21,000 Liter Stainless Steel Fermentation Vessel

Used Mueller 5,700 Gallon Jacketed Pressure Tank | 21,000 Liter Stainless Steel Fermentation Vessel, Model F.95" ID x 155" T/T. 268" OAH.Internal 25 psi at 100 degrees F, Jacket rated 100 psi at 100 degrees F.304 stainless steel, vertical, dish top and cone bottom, 16" bottom manway with 3" CBO.Serial # 384634-4, Built 2008.Previous use was brewing beer.

MFR: Mueller Corp

Stainless Steel Tank 5,800 Gallons with Agitation

Used- Stainless Steel Tank 5,800 Gallons with Agitation. Overall approx 19'H x 9' dia Approx Vessel Dimensions: 13'T X 105". Approx Vessel Capacity: 5,800 Gallons.

MFR: Unknown

Used Sharples P-660 Decanter Centrifuge | 6000 RPM | Stainless Steel | 7.5 HP Main Drive | Mounted w/ Vibration Isolation

Used Sharples P-660 Decanter Centrifuge | 6000 RPM | Stainless Steel | 7.5 HP Main Drive | Mounted w/ Vibration Isolation. Stainless Steel. Main drive motor 7.5 hp 3/60/230-460 volts, fixed speed. Backdrive motor2 hp 3/60/208 230-460 volts fixed speed. 6000 rpm max speed, 95:1 gearbox. Mounted on table with vibration isolators.

MFR: Sharples

Used Sharples P-660 Super-D-Canter Centrifuge | 6000 RPM | New Motors & PLC Panel | Stainless Steel | 1-Year Warranty

Used Sharples P-660 Super-D-Canter Centrifuge | 6000 RPM | New Motors & PLC Panel | 1-Year Warranty, stainless steel construction (product contact areas, max bowl speed 6000 rpm, single lead conveyor w/welded hardfacing wear protection, base, casing, feed pipe, 95:1 planetary gearbox, (New) 10 HP Main Drive motor, (New) 5 hp backdrive motor, mounted plate w/ vibration Isolations. Mounted on approx. 4 stainless steel stand w/casters, safety guards, (New) programable logic control/drive panel. (Reconditioned with warranty)

MFR: Sharples

Used Siemens EK1000-2 6.56 MW Steam Turbine Generator Plant

Used- Siemens 6.56 MW Steam Turbine Generator Plant, Model EK1000-2, Manufactured 1981. Siemens Model EK1000-2 multistage extraction/condensing steam turbine generator system, rated at 6,560 kW (6.56 MW) shaft output, manufactured in Germany in 1981, Serial No. T5719. Turbine designed for operation at 9,000 RPM with live steam pressure of 48.3 bar (700 PSI) at 404C (759F), intermediate steam extraction pressure of 7.3 bar (106 PSI), and condensing exhaust design pressure of 12 kPa absolute. Equipped with Siemens 6:1 speed reduction gearbox, rated at 6,900 kW continuous duty, reducing turbine speed from 9,000 RPM to 1,500 RPM. Driven generator is a Siemens Model 1DU7534-7FE82-Z three-phase synchronous alternator, Serial No. D8025106101, rated at 8,200 kVA, 11,000 volts, 50 Hz, 1,500 RPM, with 0.8 power factor. System includes associated excitation equipment, electrical control and protection panels, Siemens and GE protection components, SEL digital relays, DECS-250 digital excitation controller, lubrication system with approximately 6,300-liter oil reservoir, and (2) Alfa Laval Model M10-BDFG plate heat exchangers manufactured in 2021. Associated plant equipment includes main steam condenser and steam dump condenser, subject to confirmation of sale scope. Turbine and gearbox underwent extensive major inspection and maintenance in JulyAugust 2023, including rotor removal, internal inspections, non-destructive testing, rotor dynamic balancing, gearbox inspection, bearing inspection, generator electrical testing, and vibration assessment. Inspection records reported acceptable gearbox condition and low post-commissioning vibration levels at that time. Main condenser was retubed in 2012 and inspected in 2023. Originally installed as part of an industrial cogeneration and energy recovery system at a sulphuric acid production facility. Complete engineering documentation, maintenance records, mechanical drawings, electrical schematics, and inspection reports available.

Used Hydro-Pac LX Carbon Dioxide Compressor, Model C02.2-60-1975LX-CO2. Single stage; 400 to 2176 psi suction pressure; 2176 psi max. discharge pressure; Capacity @ 600 psig, 55 degree F inlet: 127 scfm; Capacity @ 870 psig, 55 degree F inlet: 989 scfm; 15 gpm (minimum) cooling water requirements at 60-80 degrees F. 60 HP, 3/60/230/460V motor, 120V control. Built 2020.

Used- Hydro-Pac LX Carbon Dioxide Compressor, Model C02.2-60-1975LX-CO2. Single stage; 400 to 2176 psi suction pressure; 2176 psi max. discharge pressure; Capacity @ 600 psig, 55 degree F inlet: 127 scfm; Capacity @ 870 psig, 55 degree F inlet: 989 scfm; 15 gpm (minimum) cooling water requirements at 60-80 degrees F. 60 HP, 3/60/230/460V motor, 120V control. Built 2020.

Used Atlas Copco Model GA45 Industrial Rotary Screw Air Compressor | 60 HP

Used- Atlas Copco Rotary Screw Air Compressor, Model GA45. Liquid cooled; rated 294 cfm at 107 psi; 107 psig max. discharge pressure; Elektronikon control panel. Driven by a 60 hp, 3/60/230/460 volt, 3550 rpm motor. 17537 load hours.

MFR: Atlas Copco

Used 60kW Caterpillar Natural Gas Generator – Model G3304NA, Enclosed, 3-Phase, Skid Mounted

Used 60kW Caterpillar Natural Gas Generator Model G3304NA, Enclosed, 3-Phase, Skid Mounted; 3 phase, 60Hz, 480V, 1800rpm; load tested & ready to ship.

MFR: Cat

Used Olympian G60F3 Natural Gas Generator – 60 kW Standby Power Generator with Weather Enclosure (Low Hours)

Used- Olympian Natural Gas Generator, Model G60F3. Rated standby power 60 kW, 75 kVA. Weather enclosure. Engine operates at 1,800 RPM. 3/60/120/208V. 163.2 Hours run. Serial# OLY00000JNGD01498, built 2008.

MFR: Olympian

Unused Deutsche Process Stainless Steel Winterization Skid – (3) 60-Gallon Jacketed Mixing Tanks, Buffer Tank & Triple Bag Filtration System

Unused Deutsche Process Stainless Steel Winterization Skid (3) 60-Gallon Jacketed Mixing Tanks, Buffer Tank & Triple Bag Filtration System. Consisting of (3) Identical 60 Gallon Jacketed Mixing tanks. Tank info: Vertical, Dished top and slight coned bottom. Approximately 28" diameter x 20" straight side. Vessel stamped 304 stainless steel, 90psi. Top entering dual 2 blade propellor agitation 1-1/4" diameter x 36" long shaft. Driven by a .75hp 3/60/208-230/460v 1725 rpm motor, through reducer 1:23.88 ratio. *Only comes with 2 motors*. Openings Top: 14" manway with cover, 2-1/2" for agitator, 2", (3) 1-1/4", approximately 1-1/2" center bottom outlet with ball valve, (1) spray ball. Mounted on (4) stainless steel legs welded to frame, no manufacturers tag. (1) buffer tank, 10" diameter X 20" straight side, tri-clamp cover, 1-1/2" center bottom outlet with ball valve, mounted on 3 stainless steel legs, tri-clamped to frame. (3) bag filter housings, rated 0.6MPa (87psi) at 0 to 140 degrees C (32 to 284 degreed F). 7-1/2" diameter x 37-3/4" straight side housing, with (1) filter basket 7" diameter x 29" long, 1/8" diameter perforations. 1" diameter center bottom outlet with ball valve. mounted on 3 stainless steel legs, bolted to frame. Assorted piping & stainless steel frame.