Power Generation Equipment

Used Patterson-Kelley 8 Qt Twin Shell Dry Blender – 0.26 Cu. Ft., 304 SS, 1/8 HP Motor

Used- Patterson-Kelley Twin Shell Dry Blender, (0.26) Cubic Feet (8 quart) Capacity, 304 Stainless Steel. (2) 7-1/2" Diameter x 13" long shells, 2 charge ports with (1) cover, (1) missing, oval bottom outlet with cover. Driven by a 1/8 hp, 1/60/115/230 volt, 1725 rpm gearmotor. Mounted on stand.

MFR: Patterson Kelley

Used Alfa Laval EH-W15 Heat Exchanger with Control Panel – 60kW, 10 Bar, Built 2014

Used- Alfa laval Model EH-W15 Heat Exchanger. 0,015 m3 (approximately 0.16sqft) shell/tubes volume, 10bar 160 degrees C Shell rating. 3x480 volt, 60kw power requirements. Serial# POM 215963, built 2014. Includes panel. Our freight specialists can assist you with door to door transportation and all customs documents needed to make the process go as smoothly as possible.

MFR: Alfa Laval

Used Douglas Aircraft 3-Roll Mill – 2.5" x 7" Rolls, 3/4 HP Motor

Used- Douglas Aircraft 3-Roll Mill. Includes 2-1/2" diameter X 7" face mild steel rolls. Manual spacing adjustment on rolls. Unit includes apron discharge, end plates and electrical panel. Driven by 3/4 HP, 220/440 Volts, 3-phase, 60 Hz, 1725 RPM motor. Foot pedal actuated.

Used Yale 2,000 lb. Capacity 24V Electric Sit-Down Forklift – Model MSW020LAN24CS083

Used- Yale Aprox. 2,000 lb. Capacity 24 V Electric Sit-Down Forklift, Model MSW020LAN24CS083, S/N N576930 with 2-Stage 126" Lift Height

MFR: Yale

Buss Model MKS 30 Laboratory Ko-Kneader Extruder

Used- Buss Model MKS 30 Laboratory Ko-Kneader Extruder, Serial# 97-1030 (1997). 30mm Diameter x approximate 17" long single screw. Throughput rates up to 30kg per hour. 3 Zone barrel electrically heated, water cooled. Water cooled feed throat with hopper. Driven by a 10 hp, 3/60/230/460 volt, 1740 rpm AC motor with reducer. Includes a discharge screw extruder, driven by an approximately 1.5 kw, 3/60/230/460 volt, 1710 rpm gear motor with 2 hole strand die. Includes an operators panel, a control panel with Eurotherm controllers, (2) ABB drive panels. 837 Hours used on the meter.

MFR: Buss

Used Sullair RC-250-460-3-60-A Refrigerated Air Dryer – 250 SCFM

Used- Sullair Model RC-250-460-3-60-A Refrigerated Air Compressed Dryer. 250 Scfm. Maximum air pressure 230 PSIG at maximum air inlet temperature 150 degrees F. R134a refrigerant, 35 ounces. Compressor driven by a 1.77hp, 3/60/208-230/460 volt, 3155 rpm motor. Fan driven by .39HP. Serial#1412SA01020. 3/60/460 Volt.

MFR: Sullair

Sturtevant Model 3B Simpactor Mill, 16" Diameter.

Used- Sturtevant Model 3B 16" Diameter Simpactor Mill. Carbon steel construction. Approximate capacity 3.5 tons per hour, depending on product. Set up with 6" x 6" flanged inlet with 6" diameter center bottom discharge. Includes 2-part rotating discs, driven by 10 HP inverter motor, rated for 230/460V, 3-phase, 60 Hz, 3425 RPM. Includes v-belt drive with guard. Serial# 504.

MFR: Sturtevant

Used Groen TDH-40 Table Top Kettle – 40 Quart, Gas-Heated, Steam Jacketed

Used- Groen Table Top Kettle, Model TDH-40, 40 Quart Capacity, Stainless Steel. Approximate 16-1/2" diameter x 14" deep. Self-contained steam jacketed unit with natural gas heated steam source contained within unit. Input rated 52,000 btu / hr. 2/3 bottom jacket rate 50 psi at 300 degrees F. Manual tilting with pour lip. Mounted on a base. National Board# 12100, Serial# 1988-10.

MFR: Groen

Commercial Tabletop Kettle for Sale – Groen TDH-40, Natural Gas Heated

Used- Groen Model TDH-40 Table Top Kettle, 40 Quart Capacity, Stainless Steel. Approximate 16-1/2" diameter x 14" deep. Self-contained steam jacketed unit with natural gas heated steam source contained within unit. Input rated 52,000 btu / hr. 2/3 bottom jacket rate 50 psi at 300 degrees F. Manual tilting with pour lip. Mounted on a base. National Board# 13816, Serial# 1989-4. 1/60/110 Volt.

MFR: Groen

Commercial Stainless Steel Groen TDH-40 Kettle – 40 Qt, Self-Contained Steam

Used- Groen Stainless Steel Table Top Kettle, Model TDH/40-SP, 40 Quart Capacity. Approximate 16-1/2" diameter x 14" deep. Self-contained steam jacketed unit with natural gas heated steam source contained within unit. Input rated 52,000 btu / hr. 2/3 bottom jacket rate 50 psi at 300 degrees F. Manual tilting with pour lip. Mounted on a base. National Board# 32385, Serial# 32385. 1/60/110 Volt.

MFR: Groen

Used Hytrol Belt Conveyor – 10" Wide x 518" Long | 5 Sections | .5 HP Motor | Carbon Steel Frame on Casters

Used- Hytrol Belt Conveyor. Approximate 10" wide x 518" long belt total. (5) Sections. Driven by a .5hp, 3/60/230/460 volt, 1740 rpm motor. Painted carbon steel frame with casters.

MFR: SpanTech

Used Drais Mannheim Plow Mixer/Dryer – Type TK 400-Turbu Kneter, 400L, 321 Stainless Steel

Used- Drais Mannheim Plow Mixer/Dryer, Type TK 400-Turbu Kneter. Material of construction is 321 (1.4541) stainless steel on product contact parts. Stainless steel mixing body. Total capacity is 14.12 cubic feet (400 liter), Maximum working capacity 10.6 cubic feet (300 liter). Minimum working capacity 4.23 cubic feet (120 liter). Stainless steel double jacketed for heating/cooling rated at 90 psi (6 bar). Heating/cooling surface approximately 17 square feet (1.7 m2). Inside rated for 0 psi at 122 degree F (50 degree C). FM I Becker plows driven via a Stimrad-Aufsteckgetribe gearbox, Type H 2HH 5A by an 82.5HP/55Kw-400 volt AC/50cycle/3PH Non EX motor, Type K 11 R 250 M 4 KT-200H. Mixing speed 175 RPM. Twin screw feeder, driven by 0.55 KW / 0.83 HP - 400 volt AC / 50 cucle / 3 Ph motor, 3.9" (100 mm) bottom outlet valve. Inspection door with counter weights. Overall dimensions: 12' long x 34" width x 54" high (3700 mm long x 1050 mm width x 1650 mm high). Weight 5192 pounds (2360 kgs) empty. Serial # 55918. Our freight specialists can assist you with door to door transportation and all customs documents needed to make the process go as smoothly as possible.

MFR: Draiswerke