Pharmaceutical Equipment

Used 2019 Union Process QL-25 Circulation Attritor – 27.5-Gallon Grinding Tank, 250-Gallon Recirculation Tank & 40 HP Drive

Used- Union Process Circulation Attritor System, Model QL-25. Grinding tank capacity of 27.5 gallons. Includes approximately 250 gallon recirculation tank equipped with anchor stirrer and mixer. Unit is driven by a 40 HP motor. Maximum pumping rate of 35 gpm depending on grind media and slurry viscosity. 3/60/460V. Serial # 190402, built 2019. Possible applications and suitable products include wet grinding and dispersion of coatings, inks, pigments, chemicals, minerals, metal oxides, and other pumpable slurries requiring fine and uniform particle size reduction.

MFR: Union Process

Used Fluid Air 0020P MagnaFlo MagnaCoater Fluid Bed Processor

Used Fluid Air Model 0020P MagnaFlo / MagnaCoater Fluidized Bed Dryer, Granulator And Coating System. Stainless steel lab-to-pilot scale processing system capable of fluid bed drying, granulation and Wurster coating. Equipped with a 46 liter total-volume process bowl with maximum granulating capacity of approximately 34 liters and maximum coating capacity of approximately 31 liters. Unit is mounted on casters for portability. Electrical requirements: 230V, 3-phase. Serial #10200. Overall dimensions are approximately 90" wide x 38" deep x 79" high. Possible applications include fluid bed drying, granulation and Wurster coating of compatible pharmaceutical, nutraceutical, food, chemical and other powder or particulate products.

MFR: Fluid Air

Used APV 24" x 28' Stainless Steel Desulphurizing Column

Used APV stainless steel desulphurizing column measuring approximately 24" diameter x 28' high and equipped with (15) valve trays. System was designed for approximately 1,000 imperial gallons per hour of grape juice and used for reducing sulphur dioxide concentration from approximately 1,550 ppm to 100 ppm. Includes preheater shell and tube heat exchanger. Possible applications include sulphur dioxide removal and desulphurization of compatible grape juice and other suitable liquid food or beverage processing streams.

MFR: APV

Used TUG electric tow tractor is model# MX4 400, serial number 850007, capacity 4000lbs, built November of 2002. TUG has AC drive system. TUG is 57" wide x 117" long x 66" tall. TUG has warning light...

Used-TUG electric tow tractor is model# MX4 400, serial number 850007, capacity 4000lbs, built November of 2002. TUG has AC drive system. TUG is 57" wide x 117" long x 66" tall. TUG has warning light attached. Mirrors require repair. Two Nutting quad steer trailers each with 4000 lbs capacity with accurate tracking/trailing characteristics for optimal precision maneuverability. Follows directly behind the electric tow tractor. Deck size is 50" wide x 98" long.

Used Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5...

Used-Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5 yard dump hopper with automatic dust bag shaker and air lift. Serial no. 1880.

MFR: Hi-Vac

Used Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5...

Used-Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5 yard dump hopper with automatic dust bag shaker and air lift. Serial no. 3227.

MFR: Hi-Vac

Used Kason Model K72-1-SS 72" Single-Deck Circular Vibratory Screener With 2 HP Motor

Used Kason Model K72-1-SS 72" single-deck circular vibratory screener. Unit includes one 18" deep carbon steel upper section with one 18" center opening, (2) 8" openings and one 16" x 8" covered oval side discharge. Screener has one 18" deep stainless steel deck with a funneled 10" bottom opening and 5.5" top opening. Mounted on a 36" high carbon steel base and driven by a 2 hp motor requiring 230/460 VAC, 3-phase electrical service. Approximate overall dimensions are 108" x 80" x 80". Job #83113. Serial #M7128. Manufactured May 2006. Possible applications include screening, scalping, sizing and separation of compatible powders, granules, dry ingredients and other suitable bulk solids.

MFR: Kason

Used Drexel FL40EX 4,000 lbs explosion proof electric forklift. Serial # 900826-089. Current model. Battery is 36 VDC with a 6 hr rate run time. Has a maximum lift height of 106". The fork legnth is ...

Used-Drexel FL40EX 4,000 lbs explosion proof electric forklift. Serial # 900826-089. Current model. Battery is 36 VDC with a 6 hr rate run time. Has a maximum lift height of 106". The fork legnth is 35.25". Mast has lift and tilt controls. Equipped with brass clad forks to prevent sparks. Includes MAC-Motor Model 18M1050-9C22 battery charger. Forklift weight with battery is 8530 pounds. Hour meter shows 1061 hrs. Built 9-27-91. The battery has been charged and seems to hold a charge. This forklift has low hours and appears to be in very good operational condition. (Is stored inside at our Warehouse) Good condition. Tires are for outside use. New cost is $75,776.00 including the battery and charger.

Used Two Oakes Model 8MB51, jackted high shear continuous rotor stator pin mill mixers with 316 stainless steel contact parts mounted on a stainless steel base. Rated from 50 to 1,000 lb per hour. 2....

Used-Two Oakes Model 8MB51, jackted high shear continuous rotor stator pin mill mixers with 316 stainless steel contact parts mounted on a stainless steel base. Rated from 50 to 1,000 lb per hour. 2.5" feed flanges. Mixers are driven by 5 hp, 1680 rpm motors requiring 460 V, 3 ph electricity. Allen Bradley powerflex 70 controls. System mounted on a stainless steel base frame. Overall dimensions are approximately 45" W x 50" L x 79" H

MFR: Oakes

Used Oakes model 14MC20 high shear, continuous, rotor and stator type pin mill mixer. Equipped with radial flow disc with high shear action consisting of front / rear stator and 20 hp Reeves variable...

Used-Oakes model 14MC20 high shear, continuous, rotor and stator type pin mill mixer. Equipped with radial flow disc with high shear action consisting of front / rear stator and 20 hp Reeves variable speed drive. The mix head is jacketed. The mix head has 1.5" triclamp connections. Equipped with a size 30 Waukesau positive displacement pump with 1.5" triclamp connections. All mounted in a stainless steel skinned cabinet on casters. 230/460 vac 3 ph power required. Oakes mixers are designed to homogenize or aerate slurry to produce a highly uniform and stable cell structure. OAD 41" wide x 74" long x 77.5" tall.

MFR: Oakes

Used Sweco White Water Filter. Model WWF30-3L. Serial Number 76835-C-1194. 304 stainless steel construction. Filter has a high flow rate, centrifugal screening of suspended solids down to 500 mesh (2...

Used-Sweco White Water Filter. Model WWF30-3L. Serial Number 76835-C-1194. 304 stainless steel construction. Filter has a high flow rate, centrifugal screening of suspended solids down to 500 mesh (25 Microns)(May require change of screens), a flow rate of 1350-600 GPM, (9) 10"x 20" screen panels, (9) 10" x 10" screen panels, (1) 8" infeed flanged connector, (1) 12" outfeed flanged connector, and (1) 8" concentrate flanged connector. Filter was new in 1994. Have manual on file. Good condition.

MFR: Sweco

Used 250 gallon APV Crepaco Dixie style medium shear mixer. Stainless steel food grade construction. Vessel is 40" diameter x 60" straight side length with approximately 6" dished top and bottom. The...

Used-250 gallon APV Crepaco Dixie style medium shear mixer. Stainless steel food grade construction. Vessel is 40" diameter x 60" straight side length with approximately 6" dished top and bottom. The bottom has a 3" and a 4" tri clamp ports. The top has one 18" manway w/lid. One sprayball (1.5" tri clamp) One 2" connection to the breather. Two each 1.5" and Five each 2" tri clamp connections. It has the standard 3 wheel, centrifugal fan type impellers. The drive is missing. The vessel is mounted in a stainless steel bar grate platform that is 65" x 113.5" x 57.5" high. The over all dimensions are 65"w x 113.5"l x 100.5" tall. Serial number K-0149. Good condition.

MFR: APV/Crepaco