Food and Beverage Equipment

Used APV Type P-E Single-Effect Plate Evaporator – 2,050 Lb/Hr Design

Used APV Type P-E 2,050 Lb/Hr Single-Effect Finisher Evaporator With 316 Stainless Steel Plate Sections. Employs a forced-circulation rising-falling film evaporation process and includes the evaporator frame with (16) Type 316 stainless steel plate units containing 65 total plates, a 30.5" Type 316 stainless steel snail-shell vertical separator, Type 304 stainless steel barometric condenser with steam ejector, and interconnecting vapor tubing. System was designed for a feed rate of approximately 5,590 lb/hr at 190 F with 9.0% suspended solids and 20.20% soluble solids, producing approximately 3,540 lb/hr of product at 31.9% soluble solids and 185 F, with a designed evaporation rate of approximately 2,050 lb/hr. Unit was originally designed for 19 plate units; (3) plate units are missing, so evaporation capacity will be lower as currently equipped. Additional plate units may be installed to restore the original designed evaporation rate. Overall footprint is approximately 8' wide x 9' long x 8'2" high and the system can be disassembled for shipping. Previously used for processing spent mash. Plate gaskets appear to be in good condition. Serial #1340. Good condition. Possible applications include evaporation and concentration of compatible food, beverage, fermentation, distillery, chemical and other liquid process products requiring removal of water and increased solids concentration.

MFR: APV

Used Fluid Air 0020P MagnaFlo MagnaCoater Fluid Bed Processor

Used Fluid Air Model 0020P MagnaFlo / MagnaCoater Fluidized Bed Dryer, Granulator And Coating System. Stainless steel lab-to-pilot scale processing system capable of fluid bed drying, granulation and Wurster coating. Equipped with a 46 liter total-volume process bowl with maximum granulating capacity of approximately 34 liters and maximum coating capacity of approximately 31 liters. Unit is mounted on casters for portability. Electrical requirements: 230V, 3-phase. Serial #10200. Overall dimensions are approximately 90" wide x 38" deep x 79" high. Possible applications include fluid bed drying, granulation and Wurster coating of compatible pharmaceutical, nutraceutical, food, chemical and other powder or particulate products.

MFR: Fluid Air

Used TUG electric tow tractor is model# MX4 400, serial number 850007, capacity 4000lbs, built November of 2002. TUG has AC drive system. TUG is 57" wide x 117" long x 66" tall. TUG has warning light...

Used-TUG electric tow tractor is model# MX4 400, serial number 850007, capacity 4000lbs, built November of 2002. TUG has AC drive system. TUG is 57" wide x 117" long x 66" tall. TUG has warning light attached. Mirrors require repair. Two Nutting quad steer trailers each with 4000 lbs capacity with accurate tracking/trailing characteristics for optimal precision maneuverability. Follows directly behind the electric tow tractor. Deck size is 50" wide x 98" long.

Used Kinematica Megatron model MT3-95-3A in-line homogenizer. Type 316L stainless steel construction. Disperses and emulsifies via a rotor/stator shear generator. Operates at 3600 rpm driven by a 35...

Used-Kinematica Megatron model MT3-95-3A in-line homogenizer. Type 316L stainless steel construction. Disperses and emulsifies via a rotor/stator shear generator. Operates at 3600 rpm driven by a 3540 rpm 50 hp motor. Homogenizing generator is equipped with a single mechanical seal and a cooling jacket. Internal operating pressure is 150 psi at 245 F. Flow rate up to 50 gpm (water) depending on product. Requires 440 vac 3 ph electrical power. Assembled on a stainless steel frame with adjustable feet. New 2000. Serial number R95579. Good condition.

Used Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5...

Used-Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5 yard dump hopper with automatic dust bag shaker and air lift. Serial no. 1880.

MFR: Hi-Vac

Used Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5...

Used-Hi-Vac model 240 industrial vacuum system is rated for up to 800 cfm. Belt driven by a 40 hp, 1770 rpm motor that requires 208-230/460 vac, 3 ph electricity. Inlet diameter is 3". Unit has a 1.5 yard dump hopper with automatic dust bag shaker and air lift. Serial no. 3227.

MFR: Hi-Vac

Used Kason Model K72-1-SS 72" Single-Deck Circular Vibratory Screener With 2 HP Motor

Used Kason Model K72-1-SS 72" single-deck circular vibratory screener. Unit includes one 18" deep carbon steel upper section with one 18" center opening, (2) 8" openings and one 16" x 8" covered oval side discharge. Screener has one 18" deep stainless steel deck with a funneled 10" bottom opening and 5.5" top opening. Mounted on a 36" high carbon steel base and driven by a 2 hp motor requiring 230/460 VAC, 3-phase electrical service. Approximate overall dimensions are 108" x 80" x 80". Job #83113. Serial #M7128. Manufactured May 2006. Possible applications include screening, scalping, sizing and separation of compatible powders, granules, dry ingredients and other suitable bulk solids.

MFR: Kason

Used Drexel FL40EX 4,000 lbs explosion proof electric forklift. Serial # 900826-089. Current model. Battery is 36 VDC with a 6 hr rate run time. Has a maximum lift height of 106". The fork legnth is ...

Used-Drexel FL40EX 4,000 lbs explosion proof electric forklift. Serial # 900826-089. Current model. Battery is 36 VDC with a 6 hr rate run time. Has a maximum lift height of 106". The fork legnth is 35.25". Mast has lift and tilt controls. Equipped with brass clad forks to prevent sparks. Includes MAC-Motor Model 18M1050-9C22 battery charger. Forklift weight with battery is 8530 pounds. Hour meter shows 1061 hrs. Built 9-27-91. The battery has been charged and seems to hold a charge. This forklift has low hours and appears to be in very good operational condition. (Is stored inside at our Warehouse) Good condition. Tires are for outside use. New cost is $75,776.00 including the battery and charger.

Used Two Oakes Model 8MB51, jackted high shear continuous rotor stator pin mill mixers with 316 stainless steel contact parts mounted on a stainless steel base. Rated from 50 to 1,000 lb per hour. 2....

Used-Two Oakes Model 8MB51, jackted high shear continuous rotor stator pin mill mixers with 316 stainless steel contact parts mounted on a stainless steel base. Rated from 50 to 1,000 lb per hour. 2.5" feed flanges. Mixers are driven by 5 hp, 1680 rpm motors requiring 460 V, 3 ph electricity. Allen Bradley powerflex 70 controls. System mounted on a stainless steel base frame. Overall dimensions are approximately 45" W x 50" L x 79" H

MFR: Oakes

Used Sonic Corp. Sonolator model XS-1500 inline high pressure homogenizer with a Moyno model 9P8-SSE-X 8" progressive cavity pump. The Sonolator is an in-line homogenizing device that uses high press...

Used-Sonic Corp. Sonolator model XS-1500 inline high pressure homogenizer with a Moyno model 9P8-SSE-X 8" progressive cavity pump. The Sonolator is an in-line homogenizing device that uses high pressure and ultrasonic cavitational energy to create emulsions. The positive displacement pump has a 4" sanitary tri-clamp fitting that connects to an 8" flanged inlet and the Sonolator has a 2" sanitary tri-clamp outlet. The pump has up to an estimated 20 gpm and a 600 psi discharge pressure. Driven by a 40 hp 3560 rpm motor that has a 6.2:1 reducer. Overall dimensions are 30" wide x 200" long x 32" tall. Requires 230/460 vac 3 phase electrical supply. Fair condition.

MFR: Sonic

Used Oakes model 14MC20 high shear, continuous, rotor and stator type pin mill mixer. Equipped with radial flow disc with high shear action consisting of front / rear stator and 20 hp Reeves variable...

Used-Oakes model 14MC20 high shear, continuous, rotor and stator type pin mill mixer. Equipped with radial flow disc with high shear action consisting of front / rear stator and 20 hp Reeves variable speed drive. The mix head is jacketed. The mix head has 1.5" triclamp connections. Equipped with a size 30 Waukesau positive displacement pump with 1.5" triclamp connections. All mounted in a stainless steel skinned cabinet on casters. 230/460 vac 3 ph power required. Oakes mixers are designed to homogenize or aerate slurry to produce a highly uniform and stable cell structure. OAD 41" wide x 74" long x 77.5" tall.

MFR: Oakes

Used Sweco White Water Filter. Model WWF30-3L. Serial Number 76835-C-1194. 304 stainless steel construction. Filter has a high flow rate, centrifugal screening of suspended solids down to 500 mesh (2...

Used-Sweco White Water Filter. Model WWF30-3L. Serial Number 76835-C-1194. 304 stainless steel construction. Filter has a high flow rate, centrifugal screening of suspended solids down to 500 mesh (25 Microns)(May require change of screens), a flow rate of 1350-600 GPM, (9) 10"x 20" screen panels, (9) 10" x 10" screen panels, (1) 8" infeed flanged connector, (1) 12" outfeed flanged connector, and (1) 8" concentrate flanged connector. Filter was new in 1994. Have manual on file. Good condition.

MFR: Sweco