Used Cooling Towers

Stock# 10151234

Used- BAC Cooling Tower, Model VT1-680-PMC. Certified capacity, 1750 USGPM of water from 95 F to 85 F at 78 F entering wet bulb and 0.9 PSIG spray pressure. 2 qty. 25 HP, 1800 RPM, 3 phase, 60 hz, 230/460 suit voltz, standard TEFC enclosure. Fan drives based on 0" esp. Built 1992.

Stock# 43916004

Used- Evapco NT Series Industrial Evaporator, Model NTL1-2783-500L, Approximate 12.5 tons. Galvanized housing, 42" diameter fan, 250 psig design pressure. Designed for a 0 Degree room and -10 suction. Built 2000.

Stock# 43916005

Used- Evapco NT Series Industrial Evaporator, Model NTL1-2783-500L, Approximate 12.5 tons. Galvanized housing, 42" diameter fan, 250 psig design pressure. Designed for a 0 Degree room and -10 suction. Built 2000.

Stock# 47488002

Used- Baltimore Aircoil Single Cell Cooling Tower, Open Loop, Approximate 93 Nominal Tons, Model 2412C. Galvanized steel housing, top fan. Serial# 79-1629D. Includes a 1.5 hp Goulds pump.

Stock# 48539001

Used- Marley NC Series Single Cell Cooling Tower, 130 Ton, Model-C1102CM, Open Loop System. Galvanized steel housing, stainless steel bottom pan. 72 siameter fan, driven by a 5 hp, 3/60/208-230/460 Volt, 1725 rpm motor. Designed flow of 390 gallons per minute from 95 degrees F hot to 87 degrees F cold at 80 degrees F wet bulb.

Stock# 49313002

Used- MH Fluid Cooler, Model MHF704H121G-1GSB. 600 GPM (process) 95F-85F at78 F wet bulb (30% prop. Glycol content). Heat Load: 2,851,600 btu/hr. 237 tons (does not include heat of compression from a chiller) (1ton=12,000 btuh). 190 tons (including heat of compression from a chiller) (1 ton = 15,000 btuh). Evaporation: 7.3 GPM x 60 min/hr = 438 GPH.

Stock# 44764012

Used- Marley NC Class Single Cell Open Loop Cooling Tower, Model NC2211GS, Nominal 296 tons, galvanized steel housing. Designed to cool 888 gallons per minute from 90 degrees F hot to 80 degrees F cold at 64 degrees F wet bulb. 84" Diameter fan driven by a 10 hp motor. Serial #161849-001, built in 2000.

Stock# 46782004

Used- Marley NC Class Single Cell Cooling Tower, Model NC8304F-1, Nominal 310 Tons, Galvanized Steel Housing. Designed to cool approximate 930 gallons per minute from 95 degrees F hot to 85 degrees F cold at 78 degrees F wet bulb. Approximate 96" diameter fan, driven by a 15hp, 3/60/230/460 volt, 1770 rpm motor. Serial# 202736-A1.

Stock# 46046006

Used- Evapco Closed Circuit Cooling Tower, Model ESW-153-43J. Nominal Capacity Approximate 356 Tons. Galvanized Steel Housing. Capacity to cool 150 GPM of water from 140 degrees F to 83 degrees F at 78 degrees F wet bulb. Driven by a 7.5 hp, 3/60/208-230-460 volt, 1750 rpm motor. Lower mounted coil rated at 400 psi, with (2) upper fans, driven by 15 hp, 230-460 volt, 1760 rpm motors, with vertical pump. Approximate 97,600 CFM airflow. Serial number 4-106597. Built 2004.

Stock# 47344001

Used- BAC 2-Cell Cooling Tower, Model 15425-2. Galvanized Steel, built for 1,083 gpm per cell or 361 nominal tons so the hot water distribution basin nozzles were selected for this flow rate. Nominal 425 ton cells or suitable for 1,275 gpm 95F to 85F at 78F w.b. entering air temperature. Includes: bottom equalizer connection, flume box equalizer connections for equalization of the two cold water basins.

Stock# 47344003

Used- BAC 2-Cell Cooling Tower, Model 15425-2. Galvanized Steel, built for 1,083 gpm per cell or 361 nominal tons so the hot water distribution basin nozzles were selected for this flow rate. Nominal 425 ton cells or suitable for 1,275 gpm 95F to 85F at 78F w.b. entering air temperature. Includes: bottom equalizer connection, flume box equalizer connections for equalization of the two cold water basins.

Stock# 46782005

Used- Marley NC Class Single Cell Cooling Tower, Model NC8305F, Nominal 400 Tons, Galvanized Steel Housing. Designed to cool approximate 1,200 gallons per minute from 95 degrees F hot to 85 degrees cold at 78 degrees F wet bulb. Approximate 96" diameter fan, driven by a 20 hp, 3/60/230/460 volt, 1765 rpm motor. (2) Top 8" inlets, (1) bottom 6" outlet. Serial# 202746-A2.

Stock# 46782006

Used- Marley NC Class Single Cell Cooling Tower, Model NC8305F. Nominal 400 Tons, Galvanized Steel Housing. Designed to cool approximate 1,200 gallons per minute from 95 degrees F hot to 85 degrees F cold at 78 degrees F wet bulb. Approximate 96" diameter fan, driven by a 20 hp, 3/60/230/460 volt, 1765 rpm motor. (2) Top 8" inlets, (1) bottom 6" outlet. Serial# 202746-A1.

Stock# 40536057

Used- Baltimore Air Coil Cooling Tower, Model 3436A-2. Nominal 476 Ton, one cell. Designed to 2,616 GPM of water from 95 degrees F to 85 degrees F at a 78 degrees F ambient wet bulb. Designed for 460/3/60 Volt Operation.

Stock# 48612001

Used- Evapco Induced Draft Counterflow Cooling Tower, Model AT 112-318, 304 Stainless Steel. Nominal capacity 490 ton. Unit designed to cool 1470 gallons per minute at 95 degrees F. in to 85 degrees F. out, E.W.B. 80 degrees F. Inlet pressure: 1.3 PSIG. (1) 134" Diameter Fan, driven by a 30 hp, 3/60/230-460-1775 rpm motor. Serial# 5-125319. Built 2005.

Stock# 43431001

Used- Marley NC Series Single Cell Cooling Tower, Model NC5233GS, Approximately 500 Nominal Tons. Galvanized steel housing. Approximately 96 diameter fan, driven by a 40 hp motor. Built 1997.

Stock# 43431002

Used- Marley NC Series Single Cell Cooling Tower, Model NC5233GS, Approximately 500 Nominal Tons. Galvanized steel housing. Approximately 96 diameter fan, driven by a 40 hp motor. Built 1997.

Stock# 43659017

Used- Baltimore Aircoil Series 3000 Industial Single Cell Cooling Tower, Nominal 517 Tons, Model 3766 2MC. Galvanized steel housing, cold, and hot water basins. Vertical air discharge with an approximate 120" diameter fan, driven by a 40/10hp, 3/60/460 volt, 1775/885 rpm motor.

Stock# 44014001

Used- Marley Series 220 Single Cell Cooling Tower, Approximately 613 Ton, Model N222-613. Galvanized steel housing. Designed to cool 4500 gpm. 84 Diameter fan, driven by a 25/6.2 hp, 3/60/460 volt, 1770/880 motor.

Stock# 44014002

Used- Marley Series 220 Single Cell Cooling Tower, Approximately 613 Ton, Model N222-613. Galvanized steel housing. Designed to cool 4500 gpm. 84 Diameter fan, driven by a 25/6.2 hp, 3/60/460 volt, 1770/880 motor.

Stock# 44014003

Used- Marley Series 220 Single Cell Cooling Tower, Approximately 613 Ton, Model N222-613. Galvanized steel housing. Designed to cool 4500 gallons per minute. 84 Diameter fan, driven by a 25/6.2 hp, 3/60/460 volt, 1770/880 motor.

Stock# 47112001

Used- Marley NC Class Single Cell Cooling Tower, Model NCA222CS. Approximate 650 Nominal Tons. Approximate 1,628 gallons per minute cooling capacity from hot water at 95 degree F., cold water 85 degrees F., wet bulb at 80 degrees F. Approximate 144" diameter fan, driven by 40hp, 3/60/208-230/460 volt, 890 rpm motor. Serial# 135731-001-98. Built 1998.

Stock# 47112002

Used- Marley NC Class Single Cell Cooling Tower, Model NCA222CS. Approximate 650 Nominal Tons. Approximate 1,628 gallons per minute cooling capacity from hot water at 95 degree F., cold water 85 degrees F., wet bulb at 80 degrees F. Approximate 144" diameter fan, driven by 40 hp, 3/60/208-230/460 volt, 890 rpm motor. Serial# 135731-004-98. Built 1998.

Stock# 47112003

Used- Marley NC Class Single Cell Cooling Tower, Model NCA222CS. Approximate 650 Nominal Tons. Approximate 1,628 gallons per minute cooling capacity from hot water at 95 degree F., cold water 85 degrees F., wet bulb at 80 degrees F. Approximate 144" diameter fan, driven by 40 hp, 3/60/208-230/460 volt, 890 rpm motor. Serial# 135731-002-98. Built 1998.

Stock# 47112004

Used- Marley NC Class Single Cell Cooling Tower, Model NCA222CS. Approximate 650 Nominal Tons. Approximate 1,628 gallons per minute cooling capacity from hot water at 95 degree F., cold water 85 degrees F., wet bulb at 80 degrees F. Approximate 144" diameter fan, driven by 40 hp, 3/60/208-230/460 volt, 890 rpm motor. Serial# 135731-003-98. Built 1998.

Stock# 43735001

Used- Evapco Induced Draft Cooling Tower, Model AT 24-918B. Counter flow design. Nominal capacity 675 ton. Single cell. Galvanized steel housing. Unit designed to cool 2025 gallons per minute at 90 degrees F. in to 85 degrees F. out, E.W.B. 78 degrees F. Approximately 11 diameter fan. Driven by a 50 hp, 3/60/460 volt motor. Includes bottom plenum section with pan.

Stock# 43735002

Used- Evapco Induced Draft Cooling Tower, Model AT 24-918B. Counter flow design. Nominal capacity 675 ton. Single cell. Galvanized steel housing. Unit designed to cool 2025 gallons per minute at 90 degrees F. in to 85 degrees F. out, E.W.B. 78 degrees F. Approximately 11 diameter fan. Driven by a 50 hp, 3/60/460 volt motor. Includes bottom plenum section with pan.

Stock# 46046005

Used- Evapco Cooling Tower, Model ESW-216-45N. Nominal Capacity Approximate 712 Tons. Galvanized Steel Housing. Capacity to cool 300 GPM of water from 140 degrees F to 83 degrees F at 78 degrees F wet bulb. Lower mounted coil rated at 400psi, with 132" diameter upper fan, driven by a 40 hp, 230-460 volt, 1776 rpm motor, with vertical pump. Driven by a 10 hp, 3/60/208-230-460 volt, 1755 rpm motor. Serial number 4-106595. Built 2004.

Stock# 10151235

Used- Marley, Model NC9265GM Cooling Tower. 2366 ton capacity. Rated 7100 GPM, with 75 HP motor and gearbox.