Used Ross Industries Mixers

Stock# 10288049

Used Ross Double Planetary Mixer, Model HDM-150 Gallon. Single Speed, vacuum capable, stainless steel. 150 gallon dimple jacketed can on casters, national board stamped #126, jacket rated for 100 psi at 338 F. Tank measures 44" x 28" deep. Floor mount, air over oil lift. 20 HP single speed motor, 885 RPM. Delroyd HV-120 gear reducer (74.21:1 ratio). Output RPM: 12. Two rectangular planetary mixer blades. Serial# 26593.

Stock# 11059370

Used Ross PVM-100 Triple Motion Vacuum Mixer | 100 Gallon | Stainless | High Shear | 3 Mixers | Jacketed. Mixing capacity 100 gallon. Stainless steel jacketed change can. Vacuum mixer. Triple mixers including (1) three wing anchor agitator with scrapers on side and bottom of can, driven by 10 HP motor. (1) High Speed Disperser driven by 10 HP motor. (1) Emulsifier ( High Shear rotor stator ) mixer driven by 25 HP motor. Hydraulic lift. Control Panel included.

Stock# 47577006

Used Ross HSM-40 Vacuum Double Helical Mixer Reactor. This unit will mix most things that a double planetary mixer will mix, and in many cases, better and faster. Unit has air/oil lift mechanism to raise and lower the drive to allow the removal of the mix tank. Designed for operations under vacuum & a positive pressure of 35 psi @ 350f, jacket maximum allowable working pressure 100 psi @ 350f. Minimum design metal temperature 0f at 100 psi. ross metal fabricators Serial# 11801-1, National Board# 463, CRN 15925. stainless steel contact parts. jacketed mix can with provision for thermocouple, insulated with sheathing. explosion proof motor runs on 575 volts, 3 phase, 60 hz. no controls. mixer dimensions for the ross hsm-40: 43" w x 68" l x 91" h lowered position tank id is about 23 and about 27.5 deep. Our freight specialists can assist you with door to door transportation and all customs documents needed to make the process go as smoothly as possible.

Stock# 47577014

Used Ross Ribbon Blender 42N-05S | Pharmaceutical-Grade Stainless Steel Mixer. 5 cubic feet working capacity. 7 cubic feet full capacity. Stainless steel contact parts. Center bottom outlet. Agitator is driven by a 5 HP, 60Hz/208-230/460 volt motor. With control panel. Last used in a pharmaceutical company.

Stock# 47577015

Used Ross HDM-40 Gallon Double Planetary Mixer. 5 to 40-gallon working capacity. Designed to mix under a full vacuum 29-1/2" HG. An air over oil hydraulic lift system is included to raise and lower the top of the mixer with drives and mixing blades. All product contact parts 316SS with a 150-grit finish and exterior stainless with an 80-grit finish. Driven by a 15 HP (to be confirmed) motor with a mechanical variable speed drive. All carbon steel surfaces are painted with a two component epoxy. Fitted with standard rectangular profile mixing blades.Comes with a control panel suitable for 3 PH / 60HZ /480v. Vacuum hood has a 2" sight port, a light fixture, a vacuum exhaust port and a port with 80 Watts / 120 volts EX-PROOF light. Mixer comes with one mix (not jacketed) can as follows: Made from 316 SS with interior finish 150-grit and exterior finish 80-grit, internally machined for use with a discharge press, designed for vacuum mixing, bottom outlet is a 4" Tri-Clover 316L SS flush plug connection with a 4" flush plug, mounted on casters, push pull handle. Prior use for manufacturing oral care products. Approximate weight of the mixer is 6234 Lbs. Manufactured in 1999/2000.

Stock# 51909006

Used Ross Planetary Mixer, Model: 400 liter vessel, 316L Stainless Steel. 400L (105 Gal) working capacity. Approximately 32" diameter x 35" straight side. Flat top, dished bottom. Internal design pressure rated 5 psi at 77 degrees F. Jacket rated 10 psi at 77 degrees F. Top off center entering emulsifier, driven by a 5hp, 3/60/208-230/460 volt, 3480 rpm motor. Top center agitator with (2) 3 blade propeller, driven by a 2hp, 3/60/208-230/460 volt, 1730 rpm motor thru reducer 46.65:1. Opening Top: 7" for agitator, 5", 4-3/4", 3-1/2" with sight glass, 3", (2) 2-1/2", (2) 2", 1", 1-1/2" for agitator, approximately 1" center bottom outlet. Includes spray ball. Mounted on (4) legs. Serial# SF-509A.

Stock# 54342001

Used Ross Approximately 52 Cubic Foot Stainless Steel Double Ribbon Blender, Model RB42-52SS. Sanitary Construction. Approximately 36" wide X 84" long. Driven by approximate 20 hp, 3/60/230/460 volt gear motor. Center bottom discharge with manual valve. Has top covers. Panel with AC tech controller.

Stock# 54409001

Used 100 Gallon Ross Planetary Mixer, Model PD-100, 304 stainless steel construction, high speed disperser driven by 40 hp motor, stirrer blade and planetary driven by 20 hp motor drive, 460 volt, TEFC motors, vacuum cover, (1) 100 gallon jacketed mixing can, 50 psi jackets with 2" side bottom cove-cut outlets, air over oil hydraulic lift with air tank, on board 3 hp vacuum pump, with external control panel for mixer, includes Ross EDS-100 lift and discharge press out unit, motorized lift, hydraulic press with pump and onboard controls, floor mounted, mixer and press serial# 71128, built 1997. (1) extra jacketed mixing can.

Stock# 54425002

Used Charles Ross & Son High Speed Disperser, Model HSD-3. Designed for laboratory and pilot-scale mixing and dispersion. Approximate 3-gallon working capacity, vertical shaft batch type, handling viscosities up to approximately 50,000 cP. Driven by approximately 3 HP inverter-duty TEFC motor, 230/460V, 3 phase, 50/60 Hz, with variable speed drive, 06,000 RPM and tip speeds up to approximately 5,000 ft/min. Equipped with 46 inch saw-tooth disperser blade for high shear mixing. Wetted parts are 304 stainless steel with painted carbon steel frame and V-belt drive. Features air/oil hydraulic lift with adjustable head. Bench or floor mounted, open vessel design. Suitable for paints, coatings, inks, adhesives, and chemical applications.