Contract Pharmaceutical Equipment
Stock No.:
50467054Used Roark Enterprises 25-Gallon Stainless Steel Receiver Tank – 150 PSI, Vacuum Rated
Used- Roark Enterprises 25 Gallon Receiver Tank, Stainless Steel Construction. Approximately 16" diameter x 32" straight side, dish top and bottom. Internal rated 150 psi and full vacuum at 150 degrees F. Serial# 95.709.ME1, National Board# 460.
MFR: Roark Enterprises
Stock No.:
54050001Used JWI 800N32-49-25SYLS Filter Press – 49 Chamber, 528 Sq. Ft., 800mm Plates (
Used- JWI Filter Press, Model 800N32-49-25SYLS. Total chamber volume of 25 ft (0.707 m) across 49 chambers. It features a chamber volume of 0.5 ft (0.01 m) and a total filter area of 528 ft (49 m), using 800 mm square plates with Goretex filter cloth. Approximately (49) polypropylene Plates. The overall length and width of the press are 218.63 inches (5553 mm) and 53.29 inches (1354 mm), respectively. The press uses an air-powered hydraulic pump and requires a maximum air supply of 80 scfm at 100 psi. It is equipped with a 6" bore x 24" stroke (152 mm x 610 mm) hydraulic cylinder, with a maximum hydraulic closing pressure of 4100 psi (283 bar). The system includes a 4.5-gallon (17.0 L) reservoir and uses Rykon All Weather Type-46 hydraulic oil. The feed pump pressure is rated at 100 psi, and the manifold style is air blow with precoating capability. Optional features include an auto pump control system, semi-auto shifter, drum disposal system, and Bombay doors. Serial# F05045. This unit was new in 2017. ** PLATES ARE STORED INSIDE**
MFR: JWI
Stock No.:
54265001Unused Wildcat 25 kW Natural Gas/Propane Generator | Model BS0025LPAO | Kubota WG1605 Engine | Built 2022
Unused Wildcat 25 kW Natural Gas/Propane Generator | Model BS0025LPAO | Kubota WG1605 Engine | Built 2022. Rated 25kW. 42.5kW (approx. 56 HP) at 3600 RPM. Meccalte model ECP28 L4 alternator. On casters. OAD: 60" x 30" W x 52" H.
Stock No.:
54281001Used Kaeser ASD 25 Rotary Screw Air Compressor | 25 HP | 112 CFM @ 125 PSIG | Si
Used Kaeser ASD 25 Rotary Screw Air Compressor | 25 HP | 112 CFM @ 125 PSIG | Sigma Control 2. Unit is driven by a 25hp 3/60/208-230/460v 3550rpm motor. Equipped with a Kaeser Sigma Control 2 controller with RFID capability. Hours at time of inspection indicate approximately 39,567 run hours and 30,258 load hours. Enclosure is Type 1, designed for indoor industrial use. Nameplate data includes drive motor FLA of 63/59/30 amps (depending on voltage). Unit appears complete with integrated cooling and controls, as shown. Suitable for a wide range of industrial compressed air applications. Serial# 1125, built 2012.
MFR: Kaiser
Stock No.:
54281002Kaeser ASD 25 Industrial Rotary Screw Air Compressor with Sigma Control 2 | 25 H
Kaeser ASD 25 Industrial Rotary Screw Air Compressor with Sigma Control 2 | 25 HP | 112 CFM. Rated for 125 PSIG at 112 CFM. Unit is driven by a 25hp 3/60/208-230/460v 3550rpm motor. Equipped with a Kaeser Sigma Control 2 controller with RFID capability. Hours at time of inspection indicate approximately 42,000 run hours and 33,000 load hours. Enclosure is Type 1, designed for indoor industrial use. Nameplate data includes drive motor FLA of 63/59/30 amps (depending on voltage). Unit appears complete with integrated cooling and controls, as shown. Suitable for a wide range of industrial compressed air applications. Serial# 1124, built 2012.
MFR: Kaiser
Stock No.:
54296010Used Kaeser AS 25T Rotary Screw Air Compressor with Integrated Dryer | 125 PSIG,
Used Kaeser Rotary Screw Air Compressor, Model AS 25T. Includes integrated refrigerated Dryer. Rated 125psig at 111 CFM. Driven by a 25hp, 3/60/208-230/460 volt, 3560rpm motor. Tier 1 Sound Enclosure. Kaeser Sigma Controller. Serial # 1400, Built 2008.
MFR: Kaeser
Stock No.:
54687067Used Meprotec Komet Steril Inline vertical coloid mill. Constructed of 316 stainless steel. It has a 250 liter(66 gallon) mixing tank. This homogenizer is equipped with mechanical gap distance adj...
Used-Meprotec Komet Steril Inline vertical coloid mill. Constructed of 316 stainless steel. It has a 250 liter(66 gallon) mixing tank. This homogenizer is equipped with mechanical gap distance adjustment from 3 mm to 18 mm. Homogenizer has a 2" twist style impeller. Homogenizer also has a liquid seal system. Has a 2" sanitary discharge that goes to a pneumatically operated 3 way ball valve for discharge and recirculation options. Top has a 2" sanitary fitting for recirculating material, a 3" sanitary fitting for dry material infeed and a 2.5" sanitary fitting liquid material infeed. Unit is belt driven by 25 hp electric motor. Requires 460 vac 3 ph electrical supply. Hopper and mill are supported by 3" arms with load cells. Unit also has a pneumatic 2" 3 way diverter valve. No name plate data available. Manual available. Good Condition
Stock No.:
54687070Used This Cowles disperser has a stainless steel shaft measuring 53" with a blade diameter of 17". Unit is equipped with an air over oil lift. Driven by a 50/25 hp, 1770/885 rpm motor that requires 4...
Used-This Cowles disperser has a stainless steel shaft measuring 53" with a blade diameter of 17". Unit is equipped with an air over oil lift. Driven by a 50/25 hp, 1770/885 rpm motor that requires 460 vac, 3 ph electricity. Overall dimensions are approximately 50" w x 100" l x 84" h. Motor is tagged for hazardous location however there is an attached juction box that is not.
MFR: Cowles
Stock No.:
54687098Used Waukesha model MS stainless steel horizontal colloid mill. Serial number 1000002790489. It has a conical grooved rotor and stator. The inlet and outlet are 2" sanitary threaded. This unit is all...
Used-Waukesha model MS stainless steel horizontal colloid mill. Serial number 1000002790489. It has a conical grooved rotor and stator. The inlet and outlet are 2" sanitary threaded. This unit is all mounted on a stainless steel base. The mill is driven by a 25 hp, 3530 rpm electric motor. 460 vac 3 ph power required.
MFR: Waukesha
Stock No.:
54687137Used Shar 25 hp high speed disperser. Singal speed. Mixer has a stainless steel shaft and blade. Blade is 12" diameter on 2.25" diameter shaft x 44" long. It has a hydraulic power unit. Requires 22...
Used-Shar 25 hp high speed disperser. Singal speed. Mixer has a stainless steel shaft and blade. Blade is 12" diameter on 2.25" diameter shaft x 44" long. It has a hydraulic power unit. Requires 220/440 vac 3 ph electrical supply. Lift motor is 1/2 HP 208-220/440 volts, 3 phase. Overall size 32" wide x 80" long x 82" tall.
MFR: Shar
Stock No.:
54687138Used 25 hp high speed disperser. This unit is probably a Shar. Mixer has a stainless steel shaft and blade. Blade is 12" diameter on 2.25" diameter shaft x 43" long. It has a hydraulic power unit. T...
Used-25 hp high speed disperser. This unit is probably a Shar. Mixer has a stainless steel shaft and blade. Blade is 12" diameter on 2.25" diameter shaft x 43" long. It has a hydraulic power unit. The motor is tagged for harardous locations. Requires 220/440 vac 3 ph electrical supply. Overall size 32" wide x 80" long x 84" tall.
