Chemical Equipment
Stock No.:
409352Pre-Owned Vulcan K6ETT Electric Counter Kettle | 6 Gal | 50 PSI
Used Vulcan-Hart Model K6ETT Electric Counter Tilting Kettle, 6 Gallon Capacity. Approximately 11.8" Diameter x 14-1/2" deep. Ellipsoidal bottom. 2/3 Jacketed rated 50psi at -20 to 300 degrees F. Frame mounted. National board# 21596, Serial# 46-3002235, Built 2011. 3/1PH 50/60HZ 8/10KW 208/240V requirements.
MFR: Vulcan
Stock No.:
47890001Lodige FKM600D Plow Mixer
Used- Lodige Model FKM600D batch-type plow mixer with 6 cubic feet working capacity and 10 cubic feet total capacity. 304 stainless steel, non-jacketed mixing chamber approximately 32" diameter x 50" long with 4" diameter shaft, (3) bolt-on plows, (2) bolt-on end scrapers, (2) 18" x 15-1/2" side access doors, and (2) 12" top openings. 9" x 7" bottom outlet with manually operated door and air-purge seals. Serial # 9046. Driven by an approximately 10 hp motor through Falk reducer. Includes control panel with Allen-Bradley PanelView 600 and SLC 5/04 CPU. Mounted on carbon steel stand. Suitable for dry powders, premixes, granular ingredients, spices, nutraceuticals, feed additives, chemical blends, and similar products.
MFR: Lodige
Stock No.:
50058011Used Sharples P-660 Super-D-Canter Centrifuge | 6000 RPM | New Motors & PLC Panel | Stainless Steel | 1-Year Warranty
Used Sharples P-660 Super-D-Canter Centrifuge | 6000 RPM | New Motors & PLC Panel | 1-Year Warranty, stainless steel construction (product contact areas, max bowl speed 6000 rpm, single lead conveyor w/welded hardfacing wear protection, base, casing, feed pipe, 95:1 planetary gearbox, (New) 10 HP Main Drive motor, (New) 5 hp backdrive motor, mounted plate w/ vibration Isolations. Mounted on approx. 4 stainless steel stand w/casters, safety guards, (New) programable logic control/drive panel. (Reconditioned with warranty)
MFR: Sharples
Stock No.:
50467009Buy Used 6" PFA Jacketed Column – Heat Transfer & Corrosion Protection
Used- 6" PFA lined column, jacketed.
MFR: Unknown
Stock No.:
50556009Used - Paint Media Mill, 8" x 30" Milling Chamber, 6 Gallon, 10 HP Motor
Used- Paint Media Mill. includes 8" diameter X 30" high milling chamber, approximate 6 gallon. Stainless Steel screening section, jacketed chamber. Driven by 10 HP, 220/440 V, 1740 RPM, 3-phase, 60 cycle motor. Previously used at paint processing facility and in working condition when removed from service. No Manufacturers Tag.
MFR: Unknown
Stock No.:
51065016Used Stewart Bolling 6" x 12" Two Roll Mill – Industrial Rubber & Plastics Processing
Used- Stewart Bolling 6" x 12" Pilot Two Roll Mill. Approximate 6" diameter x 12" long chrome cored rolls. Driven by 5 hp, 3/60/220/440 volt gear motor, single speed, fixed gear ratio. Unit has front and back knee safeties, and over the roll safety cage. Two point manual adjustment, split end guides. Serial# 2560.
MFR: Stewart Bolling
Stock No.:
54180001Farrel Rubber/Plastic Laboratory Calender Mill – Inverted "L" 4-Roll, Adjustable Knives
Used- Farrel 4-Roll Inverted "L" Rubber/Plastic Laboratory Calendar Mill. 6" D x 13" L rolls. 500 degrees F max. roll temp. Up to 35 RPM. Fixed center roll w/ adjustable bottom, top, and offset. Full herringbone even speed gears on one side, Full herringbone friction gears on the other side. Nylon adjustable infeed guides. (2) adjustable twin knives on bottom roll. Cable safeties on both sides of frames. SCR drive w/ dynamic braking; Operators control station with variable speeds. Variable speed 7.5 HP motor. 3/460V. Serial# 73A1499.
MFR: Farrell
Stock No.:
54280001Used Buflovak Atmospheric Double Drum Dryer | Model 6" x 8" ADDD | Pilot & R&D D
Used Buflovak Atmospheric Double Drum Dryer, Model 6" x 8" ADDD. 2 sq/ft Total drying surface area. Approximate 6" diameter x 8" face cored drum, rated 140-160 psig. Driven by a 1/2hp, 3/60/208-230/460 volt, 1725rpm motor through reducer 41.58:1 ratio. Blador VS drive. The dryer features twin chrome-plated drying drums with independent drum gap adjustment, stainless steel frame and safety guards, product feed trough with feed manifold, and doctor blade assembly. Compact unit is designed for drying slurries, purees, pastes, and other pumpable materials into flakes or powders and is well suited for R&D, product development, and small-scale production. Mounted on stainless steel frame. Job No. P1-00972, Serial# 2013-04, built 2013.
MFR: Buflovak
Stock No.:
51487002Industrial Used Belt O Matic Belt Dryer Model 320B – High-Efficiency Continuous Drying
Used Belt O Matic Belt Dryer, Model 320B. 6 5" wide by 245" long; 3 phase/480 Volt/40 Amps;LP/natural gas; 5-7 PSI pressure Range; 1,000,000 BTU rating; 10,000 maximum CFM; 7.5 HP fan, maximum drying air temperature 250 degrees F. Built 2017. Last ran wet coffee grounds.
MFR: Belt-O-Matic
Stock No.:
10755166Used Sweco LX60C168 60” Low Profile Screener – Single Deck, 3D Motion, Spare Motor & Springs, Built 2024
Used- Sweco Model LX60C168 60" Single Deck Low Profile Screener. The Sweco LX Low Profile Flow-Thru Separator allows for high capacity wet or dry scalping in a compact, low headroom design. Dual .69 hp motors mounted on opposite sides of the LX allow unrestricted flow of material and create the 3-D motion that allows oversize material full discharge, keeping the screen clear for maximum product flow. Low headroom requirements (as little as 15 inches) and straight flow design, allow the LX to fit easily into existing product lines without reworking the entire system. 12" center bottom outlet. Includes used spare motor, and six (6) spare springs. Unit is mounted on a 27" high base. No lid. " screen installed. 230-460/3/60-volt input. Serial# 554445-A-09/24, built 2024.
MFR: Sweco
Stock No.:
47147033Used Lee 60 Gallon Stainless Steel Steam Jacketed Kettle Model 60D7S
Used Lee 60 Gallon Stainless Steel Cooking & Mixing Kettle, Model # 60D7S, Serial # 32675-1, built in 2004. Stainless steel 60 gallon kettle equipped with a single-action scraped-surface agitator with scrapers missing. Steam jacket is rated for 90 psi at temperatures up to 332 F, National Board number 9758. Kettle has a 1.5" diameter outlet with pneumatic discharge valve and is driven by a 1 HP, 3 phase, 60 cycle, 230/460 volt motor. Suitable for cooking, heating and mixing applications involving products that can be processed in a steam-jacketed, agitated kettle.
MFR: Lee Ind
Stock No.:
47147036Used Groen RA-60 60 Gallon Stainless Steel Jacketed Cooking Kettle with Agitator
Used Groen 60 gallon stainless steel jacketed cooking and mixing kettle, Model # RA-60, Serial # 03588, National Board number 139462, equipped with a single-action scraped-surface agitator with scrapers missing, 125 psi steam jacket rated up to 353 F, 1.5" diameter outlet, and 1.5 HP, 3-phase, 60-cycle, 230/460-volt motor with final agitation speed of 34 RPM. Suitable for batch cooking, heating, blending, and mixing applications and products requiring low-speed scraped-surface agitation.
MFR: Groen
