Used Non Plastic Extruders

Stock# 13745002

Used- Weiler Grinder with Pieco Reclaim Grind Unit. 3 HP/#5-10:11-1/2 Variable Valve 500X1/4R; Stainless box with drive and air system; 1978 BC Style 4-Arm knife holder.

Stock# 49578002

Used- Hosokawa Bepex BX150 Extruder. 316 stainless steel. Includes (2) screens, 2 mm and 1.2 mm.

Stock# 50813001

Used- Wenger Extruder & Pet Food System, Model X185. Consisting of: Wenger X185 Extruder, Sanitary Design, Full Automation Controls, HIP Pre-Conditioner. Includes Wenger Back Pressure Valve, Pre-Plumb and Wire Set up for faster and easier install, Pneumatic Take Away system from Extruder to Dyer Inlet. Includes Pasteurizing Unit for increased sanitization features, Wenger Horizontal Triple Pass Dryer. Last Section Cooling Zone, Sanitary Design, Upgraded Sanitary Design Internals for ease of cleaning. Bulk Density System Included on Inlet and out let of Dryer, Full Automation Capable, Extrutech Vertical Cooler. Sanitary Design with Stainless Upgrade. Wenger Liquid Coating System for Pet Food. 316 Stainless Upgrade Dust Tight.

Stock# 51438001

Used- 10" Bonnot Extruder with 100 HP SEW Gearmotor and 10 HP Rotary Cutter. Extruder is complete with screw auger and ready to run. Auger has been hard faced with weld overlay and has medium wear. The extruder also comes with the following spares: spare barrel with installed liner, spare unused auger hard faced with weld overlay, brand new spare 100 HP SEW gearmotor, brand new spare 10 HP Nord gearmotor for the cutter.

Stock# 51354002

Used- The Bonnot Co. 12" Extruder. 12" Diameter x 47" long screw. Jacketed grooved barrel section. Driven by a 40 hp, 3/60/230/460 volt, 1775 rpm motor. Infeed 18" x 18". Centerline height approximately 41-1/2". Mounted on painted carbon steel frame with 4 legs. Serial # 83605. S.O. 7019A. Built 7-12-00.

Stock# 51354003

Used- The Bonnot Co. 12" Extruder. 12" Diameter x 47" long screw. Jacketed grooved barrel section. Driven by an approximate 40 hp, 3/60/230/460 volt, 1775 rpm motor. Infeed 18" x 18". Centerline height approximately 41-1/2". Mounted on painted carbon steel frame with 4 legs. Serial # B3269. S. O. B6669. Date 8-16-93.

Stock# 51354001

Used- The Bonnot Co. 12" Extruder. 12" Diameter x 47" long screw. Jacketed grooved barrel section. Driven by a 40 hp, 3/60/230/460 volt, 1775 rpm motor. Infeed 18" x 18". Centerline height approximately 41-1/2". Mounted on a painted carbon steel frame. Serial # 2956. S.O. 6297. Built 6-14-85.