Used Drum Dryers

Stock# 11585095

Used- Buflovak 6" x 8" Single Drum Flaker. 1 square foot surface area. Model 6-8 SDF. Stainless Steel contacts. Reeves varispeed drives. Built 1989.

Stock# 51781001

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls, each rated 160 psi at -20 to 650 degrees F, serial #s 490K and 491K. National Board #s 425 and 426, built 2006, certified by PFE Rolls. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781002

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. (1) Rated 160 psi at -20 to 650 degrees F. Serial # 18463A, National Board # 9159, Built 1993, certified by Blaw Knox. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781003

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. Approximate rating 100 psi at 450 degrees F. National Board# 1782-2, Certified by Beloit / Overton Machine Co, Built 1962. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781004

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. Approximate rating 160 psi at 450 degrees F.. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781005

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. Approximate rating 160 psi at 450 degrees F.. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781007

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. Each rated 160 psi at 450 degrees F., serial #'s F7651-1 and F7651-2, National Board #'s 2291-1 and 2291-2, built 1969, certified by Beloit Corporation. Each roll set up for a hydraulic drive. Includes 15hp Hydraulic power pack. Dual knife scraper, top fume hood, edge guides, (2) approximate 9" wide x 10 long side mounted discharge rubber belt conveyors and panel. Mounted on stainless steel end frames.

Stock# 51781008

Used- Double Drum Dryer. (2) Approximate 42" diameter x 120" face chrome plated rolls. (1) Rated 160 psi at -20 to 650 degrees F., serial# 18723B, National Board# 9413, built 1998, certified by Buffalo Technologies. Each roll set up for a hydraulic drive. 15HP Hydraulic power pack available for additional cost. Dual knife scraper, top fume hood, edge guides and panel. Mounted on stainless steel end frames.

Stock# 51781010

Used- Single Drum Dryer Roll Only. Approximate 42" diameter x 120" face chrome plated roll. Rated 175 psi at 32 to 450 degrees F., serial# 10790-25481-25379, National Board# 8649, built 2010, certified by GL&V.

Stock# 51781011

Used- Single Drum Dryer Roll Only. Approximate 42" diameter x 120" face chrome plated roll. Rated 160 psi at 450 degrees F., serial# 3487-2, National Board# 1316-2, built, certified by Overton Machine.

Stock# 51781012

Used- Rechromed Single Drum Dryer Roll Only. Approximate 42" diameter x 120" face chrome plated roll. Rated 175 psi at 32 to 450 degrees F., serial# 10789-25480-25378, National Board# 8648, built 2010, certified by GL&V.

Stock# 51781013

Used- Single Drum Dryer Roll Only. Approximate 42" diameter x 120" face chrome plated roll. Rated 160 psi at 450 degrees F., serial# 3487-1, National Board# 1316-1, certified by Overton Machine.

Stock# 52079001

Used-GL&V Double Drum Dryer. Chrome plated carbon steel roll approximate 42" (1075 mm) diameter x 3690 mm (144") st. side rolls with scraper blades. Rated 150 psi (10 bar) at 32-450 degrees F (0-232.22 degrees C). Driven by (2) 7.5 HP, 3/60/230/460-volt, 1765 rpm gear motors. 304 Stainless steel top cover. Frame mounted on 4 legs. (1) Control panel with A/B Powerflex 40 drives. Complete with pipes, valves and additional infrastructure.

Stock# 48917001

Used- Lot of (4) GMF Gouda T 15/40 KD Double Drum Dryers, 1508 MM (59.37") Diameter X 4000 MM (157.48") Face. Cast Iron Rolls. Not Chrome Plated.204 square feet per drum / 408 square foot total area. Drums rated 8.5 bar (123 psi) at 191 degrees C. MAWP 12 bar. Drum speed 1.5-15 rpm. 18.5 KW drive. Two (2) discharge augers. 560 mm diameter x 5,995 mm Long. Driven by 1.5 kW motor, 80 rpm. Dryer is equipped with stainless steel hood. Hydraulic bearing lube system. Mfg. 2012.

Stock# 46702004

Used- GMF Gouda Single Drum K Flaker, Type K17.5/36, Approximate Cooling Surface 215 Square Feet. Approximately 68.90" (1750mm) Diameter x 141.7323" (3600mm) face cored chrome plated carbon steel drum. Includes (1) knife scraper with blade, end drum scrapers, manually adjustable. Hydraulically driven by a approximate 30 hp, 3/60/230/460 volt, 1160 rpm motor, Rexroth Hydraulic unit. Top fume hood with (2) 16", (2) 4" openings. Jacketed 304 stainless steel trough with (4) side access doors. Mounted on a carbon steel frame. Includes discharge conveyor, driven by a 3 hp, 1750 rpm gear motor, 25.6 to 1 ratio.

Stock# 46702005

Used- GMF Gouda Single Drum K Flaker, Type K17.5/36, Approximate Cooling Surface 215 Square Feet. Approximately 68.90" (1750mm) Diameter x 141.7323" (3600mm) face cored chrome plated carbon steel drum. Includes (1) knife scraper with blade, end drum scrapers, manually adjustable. Hydraulically driven by a approximate 30 hp, 3/60/230/460 volt, 1160 rpm motor, Rexroth Hydraulic unit. Bolt-on top fume hood with (2) 16", (2) 4" openings. Jacketed 304 stainless steel trough with (4) side access doors. Mounted on a carbon steel frame. Includes discharge conveyor, approximate trough 258" long x 15" wide x 16" deep, 14" diameter x 256" long screw on 4" diameter shaft. Machine # K:186/101R DS 176, Built 1994.

Stock# 46702003

Used- GMF Gouda Single Drum K Flaker, Type K17.5/36, Approximate Cooling Surface 215 Square Feet. Approximately 68.90" (1750mm) Diameter x 141.7323" (3600mm) face cored chrome plated carbon steel drum. Includes (1) knife scraper with blade, end drum scrapers, manually adjustable. Hydraulically driven by a approximate 30 hp, 3/60/230/460 volt, 1160 rpm motor, Rexroth Hydraulic unit. Bolt-on top fume hood with (2) 16", (2) 4" openings. Jacketed 304 stainless steel trough with (4) side access doors, rated 174 psi (12 Bar) at 375.8 degrees F (191 degrees C). Mounted on a carbon steel frame. Includes discharge conveyor, approximate trough 148" long x 14-3/4" wide x 16" deep, 14" diameter x 148" long screw on 4" diameter shaft. Machine# K196:118R BR 193, Built 1996.

Stock# 44813004

Used- R Simon Stainless Steel Chill Drum Dryer, Model 4718. 4m Long x 2m wide, 5.5 bar G, design pressure 6.1, bar design temperature -1 degree, hydraulic test pressure 9.1, 316 grade stainless steel. Includes CIP spray cleaning system, discharge belt conveyor 600 mm wide x 8500 mm long, freon Teflon scraper, 30 kw at 22 rpm, 415 volt.