Used Leistritz Corporation Plastics Equipment

Stock# 10755170

Used Leistritz Twin Screw Extruder, Type MIC 27-GL-36D. (2) 1.05" (27 mm) diameter screws. 36:1 L/D Ratio. Co-rotating. 8-barrel housing section electrically heated, water cooled. (1) Degassing port. Maximum screw speed 500 RPM. Gearbox is direct driven via a 15.75 HP/10.5 kW, 1450/1740 RPM A/C motor. Free standing control panel with microprocessor and interconnecting wiring. Type 330.10056.01. Built in 2006. Includes manuals. Unit is capable of running co or counter rotation via slip ring in gearbox. Serial# 3318.

Stock# 40425043

Used Leistritz Twin Screw Pelletizing Line, Model Micro18-GGL. 18 mm Screws, counter rotating screws, 40:1 1/d, 500 rpm screw speed, electrically heated, water cooled barrel, 2.3 kw, 210/260 volt, 2950 rpm de motor with SCR controller, (8) barrel sections with (1) jacketed feed, (1) vented, (1) vented and plugged, (5) non vented barrel sections, on board control panel with (10) Eurotherm controllers, with 10" wide x 96" long cooling conveyor. Leistritz Serial# 481 739. 2" Film die and a rod die for the extruder.

Stock# 52346004

Used Leistritz Lab Sheet Line, Includes the following- Leistritz Extruder, Model ZSE27 MAXX-40D. 29.8 Kw Main Drive, 1200 rpm Screw Speed. 320 Hours. (4) Schenck Feeders. (2) AEC Chilling Units. (1) Sterlco Unit. (1) Water Trough. Calendaring Web Handling Stack System (Roll Stack OS2):Web Alignment (Pull Roll 2 NIP, OS3"):Rewind Unit. (3) Flat Line Roller Conveyors. Fabric Rack holder. MAAG Pelletizer. Built in 2018.

Stock# 54045001

Used Leistritz ZSE-60 GL Twin Screw Extruder 36:1 L/D, 150 HP, Side Stuffer, Strand Dies, Screws & Spares. With (9) modular barrel sections. 114 kW / 150 HP Baumueller DC motor, 500 rpm max. screw speed, Barrels are electrically heated and internally cored for liquid cooling. Includes stand-alone Electrical enclosure/control panel (controls appear non-operational), LSB-47 twin screw side stuffer, Stand-alone pump tank/heat exchanger for barrels cooling, Two (2) Complete screw sets, segmented design with splined shafts, fully assembled, Approximately 25 pairs of spare screw elements, consisting of both flighted/conveying and mixing elements, Two (2) complete swing gate-type strand die assemblies, Three (3) or four (4) spare die plates. Numerous (approx.. 8-10) spare barrel closures & inserts Yr. 2000. Includes Allen Bradley DC Motor Drive. 480 50/60hz.