Used 1200mm Amut coextrusion sheet line: 90mm extruder, 50mm coextruder, changer, gear pump, coex block die, 3 roll stack, haul off, winder, hyd nip, 1993. 90mm single screw extruder circa 32:1 L/D ...

Used-1200mm Amut coextrusion sheet line: 90mm extruder, 50mm coextruder, changer, gear pump, coex block die, 3 roll stack, haul off, winder, hyd nip, 1993. 90mm single screw extruder circa 32:1 L/D ratio. 117 kW DC motor, electrically heated, air cooled barrel. 17 kW DC motor. DC drive panel, 18 zone operator's temp control panel. Barrel currently vented but plugged and fitted with 2 stage screw. (General purpose screw has run HIPS extensively with vent open and limited runs on olefins with vent plugged for material development.) Lantern screen changer with power pack. Dynisco gear pump with 11 kW DC motor. Model PS400 with control panel. 2001. Approximate 3D static mixer. 50mm Welex single screw coextruder with fan cooled barrel. DC motor with drive. Individual control panels. Plate type coex block with option of adding additional coextruder (extra cost). 1020mm wide Amut flexible lip sheet die. 1200mm 3 roll stack, 250mm x 340mm x 340mm diameter rollers. Hydraulic nip with power pack. Razor and shear cutting for edge trim. Edge trim waste wind up. 2 roll haul off, twin winder, Frigomeccanica 3 zone pump group; combination of 3 zone pump group (one to each roll with water pump, heat exchanger and heater block and valves), plus air cooled chiller unit all on one skid. Dimensions: extruder, screen changer, gear pump, coex block and die 6200mm; clearance gap 1500mm; stack and haul off 3500mm; clearance gap winder 2000mm.